Park Brake Cable Replacement - Front

Park Brake Cable Replacement - Front

Removal Procedure

1. Disable the park brake cable automatic adjuster.
2. Remove the park brake pedal.




3. Roll the carpet back to access cable grommet.
4. Raise and support the vehicle.




5. Disengage the grommet and the cable from the floor pan.
6. Disconnect the front cable from the rear cable.
7. Remove the cable from the body mount by depressing the retaining tabs.
8. Remove the cable.

Installation Procedure




1. Install the cable.
2. Snap the retainer tabs into the body mount.
3. Connect the front cable to the rear cable.
4. Route the cable in through the floor pan and engage the grommet.
5. Remove the safety stands.
6. Lower the vehicle.




7. Roll the carpet into place.
8. Install the park brake pedal.
9. Enable the park brake cable automatic adjuster.