Sunroof / Moonroof Weatherstrip: Service and Repair

Sunroof Finishing Lace Replacement

Removal Procedure




1. Beginning at the joint, pull the sunroof opening trim lace from the headliner.
2. Remove the sunroof opening trim lace from the sunroof module flange.

Installation Procedure






Important: When installing the lace, ensure the corners are fully seated and no slack exists as you go around the opening.

1. Start the joint aligned with the forward tab and hook and loop strip on the left side of the opening.
2. Press the trim lace (2) into place onto the sunroof module flange (1) until fully seated around the sunroof opening.
3. Pull the finish lace draw cord downward and remove the cord from the periphery of the opening.
4. Ensure the finishing lace (2) is properly seated over the outer surface of the headliner (3).