Campaign - Liftgate Applique Separation
Bulletin No.: 07165Date: June 19, 2007
SERVICE UPDATE
Subject:
07165 - Service Update for Inventory Vehicles Only - Liftgate Applique' Separation - Expires September 15, 2007
Models:
2007 HUMMER H2
THIS SERVICE UPDATE INVOLVES VEHICLES IN DEALER INVENTORY ONLY AND WILL EXPIRE SEPTEMBER 15, 2007.
Purpose
This bulletin provides a service procedure to inspect the liftgate applique' on certain 2007 HUMMER H2 vehicles. On some of these vehicles, the liftgate applique' may separate from the liftgate, resulting in an uneven, rippled surface or contact with the rear edge of the vehicle roof when the liftgate is opened. Depending on the results of the inspection, dealers are to either modify or replace the applique'.
This service procedure should be completed on involved vehicles currently in dealership inventory as soon as possible but no later than September 15, 2007, at which time this bulletin will expire.
Vehicles Involved
A list of involved vehicles currently in dealer inventory is available on the "Service Update Bulletin Information" link under the "Service" tab in DealerWorld (US) or attached to the Dealer Communication (Canada), used to release this bulletin.
Dealers are to confirm vehicle eligibility prior to beginning repairs by using the GM Vehicle Inquiry System (GMVIS).
Parts Information
Parts required to complete this service update are to be obtained from General Motors Service and Parts Operations (GMSPO). Please refer to your "involved vehicles listing" before ordering parts. Normal orders should be placed on a DRO = Daily Replenishment Order. In an emergency situation, parts should be ordered on a CSO = Customer Special Order.
Service Procedure
A warped liftgate applique does not require replacement; however, if the seal is visible above the surface of the roof panel or if the liftgate applique is damaged from opening the liftgate, the liftgate applique must be replaced. The new liftgate applique must be modified before installation.
Inspect the liftgate applique' and seal for damage.
If the liftgate applique' and seal are not damaged, the current liftgate applique' may be modified and reused.
If the liftgate applique' and seal are damaged, the liftgate applique' will need to be replaced. Modify the new liftgate applique' before installation.
Remove the liftgate applique' from the vehicle. Refer to Liftgate Applique' Replacement in SI.. Modify the liftgate applique' attachment slots.
Place the liftgate applique' on a work bench.
Remove the driver's and passenger's side pushpins from the liftgate applique'.
Using a ruler and pen, measure and mark the 4 mm (5/32 in) inboard position. Refer to the illustration. Use a Dremel tool, drill bit, file, or equivalent to increase the size of the pushpin slot in the applique.
Open driver's side pushpin slot 4 mm (5/32 in) inboard toward the center of the liftgate applique'.
Place liftgate applique' on the liftgate and tuck the seal (1) under roof panel.
Align the liftgate applique' hole (1) with the liftgate hole.
Install the pushpins (1) on both sides of the liftgate applique'. The pushpins may need to be seated with a rubber mallet.
Secure the applique' to the liftgate with two screws. Refer to Liftgate Applique' Replacement in SI.
Install the high mounted stop lamp. Refer to Refer to High Mounted Stop Lamp Replacement in SI.
Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement in SI.
Claim Information
For vehicles repaired under this service update, use the table.
Disclaimer