Hood Latch Release Cable: Service and Repair

Hood Latch Release Cable Replacement

Removal Procedure

1. Open the hood.




2. Remove the cable end (1) from the latch.
3. Release the retainer clips that retain the hood release cable to the cowl.
4. Open the driver side door.
5. Remove the driver side kick up panel.




6. Remove the fastener (1) retaining the hood release handle to the vehicle.




7. From the driver side compartment area, pull the cable through the access hole in the cowl (2).

Installation Procedure




1. From the driver side compartment area, route the cable through the access hole in the cowl (2).
2. Attach the retainer clips that retain the hood release cable to the cowl.
3. Connect the cable end (1) to the hood release latch.
4. Set the hood release handle in place.

Notice: Refer to Fastener Notice.

5. Install the fastener retaining handle to the vehicle.

Tighten the fasteners to 9 N.m (7 lb ft).

6. Install the driver side kick up panel.