Global Positioning System Antenna: Service and Repair

Global Positioning System (GPS) Antenna Replacement

Removal Procedure




1. Remove the instrument panel (I/P) top pad.
2. Remove the radio.

Important: Observe the routing of the global positioning system (GPS) antenna cable to ensure the GPS antenna cable is routed properly during installation.

3. Remove the GPS cable from the I/P structure.
4. Remove the GPS antenna screw (1).
5. Slide the GPS antenna (2) toward the passenger side of vehicle to remove the antenna from the I/P structure.
6. Remove the GPS antenna (2) from the vehicle.

Installation Procedure




1. Install the GPS antenna (2) to the I/P bracket.
2. Route the GPS antenna cable to the radio opening, as noted in the removal procedure.
3. Slide the GPS antenna (2) toward the driver side of vehicle and align the screw hole.

Notice: Refer to Fastener Notice.

4. Install the screw (1).

Tighten the screw (1) to 2 N.m (18 lb in).

5. Install the radio.
6. Install the I/P top pad.