B1785
DTC B1770, B1775, B1780, B1785, B1790, B1805, or B2415
Circuit Description
The seat adjuster motors are controlled by the driver seat module through the adjuster motor control circuits. In an inactive state both of the motor control circuits are grounded within the driver seat module. In an active state the driver seat module switches the appropriate motor control circuit to battery positive voltage. The direction of the adjuster motor rotation is determined by which of the motor control circuits is switched to battery positive voltage while the other remains grounded. During adjuster motor operation the driver seat module also monitors the current flow through the motor control circuits.
DTC Descriptors
This diagnostic procedure supports the following DTCs:
* DTC B1770 Driver Seat Horizontal Motor Circuit
* DTC B1775 Driver Seat Front Vertical Motor Circuit
* DTC B1780 Driver Seat Rear Vertical Motor Circuit
* DTC B1785 Driver Seat Recline Motor Circuit
* DTC B1790 Driver Seat Lumbar Motor Circuit
* DTC B1805 Driver Seat Side Bolster Motor Circuit
Conditions for Running the DTC
The system voltage must be between 9-16 volts.
Conditions for Setting the DTC
The motor control circuit monitored by the driver seat module is determined to be shorted to ground, battery positive voltage, or open.
Action Taken When the DTC Sets
* The seat motor with a current status DTC will be disabled.
* When the fault is no longer present a history status DTC will be stored, and motor operation will be restored.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present the DTC will be a history status code.
* The history DTC will be cleared after 100 error free ignition cycles, or by using the scan tool clearing DTCs feature.
Diagnostic Aids
When an adjuster motor control circuit is shorted to ground the driver seat module will also set a DTC B3962.
Test
