Flex Plate: Service and Repair

Engine Flywheel Replacement (w/Automatic Transmission)

Tools Required
^ J45059 Angle Meter

Removal Procedure
1. Remove the transmission.





2. Remove and discard the flywheel bolts.
3. Remove the flywheel.
4. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection.

Installation Procedure





1. Position the flywheel to the crankshaft

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the NEW flywheel bolts.
Tighten the bolts a first pass to 25 Nm (18 ft. lbs.). Using the J45059 rotate the bolts a final pass an additional 50 degrees.
3. Install the transmission.