Fuel Hose/Pipes Replacement - Chassis

FUEL HOSE/PIPES REPLACEMENT - CHASSIS

REMOVAL PROCEDURE

CAUTION:
- Refer to Fuel and EVAP Pipe Caution in Service Precautions.
- Refer to Gasoline/Gasoline Vapors Caution in Service Precautions.

NOTE: Refer to Fuel and Evaporative Emission (EVAP) Hose/Pipe Connection Cleaning Notice in Service Precautions.

1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.




2. Disengage the quick connect fitting lock clip (1).
3. Disconnect the fuel feed line quick connect (2).
4. Open the retaining clips (3, 4).
5. Remove fuel feed line from the clips.
6. Raise and support the vehicle. Refer to Vehicle Lifting.
7. Disconnect the fuel feed line from the fuel tank.




8. If equipped with an automatic transmission, open the retaining clips attaching the lines to the transmission.
9. Remove the fuel feed line from the clips.




10. If equipped with a manual transmission, open the retaining clips attaching the lines to the transmission.
11. Remove the fuel feed line from the clips.

INSTALLATION PROCEDURE




1. Install the fuel feed line to the clips.
2. If equipped with a manual transmission, close the retaining clips attaching the lines to the transmission.




3. Install the fuel feed line to the clips.
4. If equipped with an automatic transmission, close the retaining clips attaching the lines to the transmission.




5. Disconnect the fuel feed line from the fuel tank.
6. Lower the vehicle.
7. Install fuel feed line to the clips.
8. Close the retaining clips (3, 4).
9. Connect the fuel feed line quick connect (2).
10. Engage the quick connect fitting lock clip (1).