Engine Mount Replacement - Right

Engine Mount Replacement - Right
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tires and wheel assembly.
3. Remove the engine shield, if equipped.
4. Support the engine using a jack stand and a block of wood.





5. Remove the right engine mount-to-frame bracket through bolt.
6. Loosen the left side through bolt.
7. Raise the engine using the jack stand. The engine will tilt to one side.





8. Remove the engine mount bolts.
9. Remove the engine mount. You will need to articulate the mount in order to remove the mount.

Installation Procedure
1. Install the engine mount. You will need to articulate the mount in order to install the mount.





2. Install the engine mount bolts until snug, following the installation sequence.

Notice: Refer to Fastener Notice in Service Precautions.

3. Tighten the bolts.
Tighten the bolts to 50 Nm (37 ft. lbs.).
4. Lower the engine.





5. Install the right engine mount-to-frame bracket through bolt.
Tighten both of the engine mount-to-frame bracket bolts to 85 Nm (63 ft. lbs.).
6. Remove the jack stand.
7. Install the engine shield, if equipped.
8. Install the tire and wheel assembly.
9. Lower the vehicle.