C0558

DTC C0558

Diagnostic Instructions

- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
- Review Strategy Based Diagnosis for an overview of the diagnostic approach.
- Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0558: Calibration Data Not Programmed/Learned, vehicle configuration not programmed.

Circuit/System Description

The electronic brake control module (EBCM) must be programmed using SPS.

Conditions for Running the DTC

- Ignition ON.
- Ignition voltage is greater than 10 volts.

Conditions for Setting the DTC

The EBCM has not been programmed.

Action Taken When the DTC Sets

A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

- The condition for the DTC is no longer present.
- The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Circuit/System Verification

Verify that DTC C0558 is not set.
-> If the DTC is set, program the EBCM. If the DTC resets, replace the EBCM.