Positive Crankcase Ventilation (PCV) Valve Replacement (Left)

Positive Crankcase Ventilation (PCV) Valve Replacement (Left)
Removal Procedure





1. Important: After removing the charged air cooler duct, cover the turbocharger opening with tape in order to prevent entry of objects.

Loosen the charged air cooler inlet duct connector to turbocharger clamp (1).

2. Important: Do not use a screwdriver or other tool to pry the hose loose. The hose can be torn or damaged. Loosen the hose by twisting.

Remove the charged air cooler inlet duct connector (4) from the turbocharger.





3. Remove the positive crankcase ventilation (PCV) cover screws.
4. Remove the PCV cover, diaphragm, and spring.
5. Clean and inspect the cover, diaphragm, and spring.
6. Discard the diaphragm if damage is found.

Installation Procedure





1. Install the spring, diaphragm, and cover.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the PCV cover screws.
^ Tighten the screws to 4 Nm (35 inch lbs.).





3. Remove the tape from the turbocharger openings.

Important: Lubricate the end of the duct prior to installation.

4. Install the charged air cooler inlet duct connector (4) to the turbocharger.
5. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
^ Tighten the clamp to 6 Nm (53 inch lbs.).