Diesel Injection Line Bracket And Clamp

Figure 3-50: Injection Line Bracket Removal/Installation:

Diesel Injection Line Bracket And Clamp

Removal
1. Remove console and engine covers.
2. Remove air horn.
3. Remove bracket (Figure 3-50).
4. Remove bracket from valve cover studs.
5. Remove line clamps if necessary.

Figure 3-51: Injection Line Bracket Removal/Installation (Driver-Side):

Installation
1. Install clamps on lines if removed.
2. Install bracket on valve cover studs (Figure 3-51). Tighten bracket nuts to 13-20 lb-ft (18-27 N.m).
3. Install air horn.
4. Install console and engine cover.