Transmission Mount Replacement

Transmission Mount Replacement

1. Do the 12 volt battery removal procedure.

2. Turn the battery module switch OFF.

3. Remove the air cleaner Service and Repair.

4. Disconnect the battery cables (A) from the battery terminal fuse box.





5. Remove the harness clamps (B).

6. Remove the harness clamp (A). Remove the two bolts (B) and loosen the two bolts (C), then remove the battery base (D).





7. Remove the PCM Service and Repair.

8. Disconnect the IMA power cable connector and the harness clamp.

9. Support the transmission with a jack and a wood block under the transmission.

10. Remove the harness holders (A).





11. Remove the transmission mount bolts (B) and nuts (C), then remove the transmission mount bracket (D).

12. Remove the transmission mount.





13. Install the transmission mount, and loosely install the new transmission mount mounting bolts, then tighten the transmission mount mounting bolts in the numbered sequence shown.

14. Install the transmission mount bracket (A), and loosely install the new transmission mount bracket mounting bolts (B) and nuts (C).





15. Install the harness holders (D).

16. Remove the jack and wood block from under the transmission.

17. Raise the vehicle on the lift.

18. Loosen the torque rod mounting bolt and nut (A).





19. Lower the vehicle on the lift.

20. Tighten the transmission mount mounting bolts and nuts in the numbered sequence shown.





21. Raise the vehicle on the lift.

22. Tighten the torque rod mounting bolt and nut in the numbered sequence shown.






23. Install the battery base (A), then install the harness clamp (B).






24. Connect the battery cables (A) to the battery terminal fuse box.





25. Install the harness clamps (B).

26. Install the PCM Service and Repair.

27. Connect the IMA power cable connector and the harness clamp.

28. Turn the battery module switch ON.

29. Do the 12 volt battery installation procedure.

30. Install the air cleaner Service and Repair.