CVT Housing Selector Control Shaft Removal/Installation

CVT Housing Selector Control Shaft Removal/Installation

1. Remove the bolt (A) and the lock washer (B), then remove the control lever (C) from the selector control shaft (D).





2. Remove the selector control shaft from the transmission housing, then check the control lever and the selector control shaft for wear or damage, and replace them if necessary.

3. Check for fluid leaks between the transmission housing and the oil seal (E). If there is a fluid leak, replace the oil seal with a new one.

4. Install the selector control shaft in the transmission housing, and install the control lever on the selector control shaft.

5. Install the bolt with a new lock washer.