CVT Differential Carrier Bearing Side Clearance Inspection

CVT Differential Carrier Bearing Side Clearance Inspection

Special Tools Required

- Driver Handle, 40 mm I.D. 07746-0030100

1. Remove the oil seal from the transmission housing CVT Differential Oil Seal Replacement.

2. Install the set ring (A) in the transmission housing.






3. Install the differential assembly (A) in the transmission housing, then drive the differential to seat in the housing using the 40 mm driver handle.






4. Install the three dowel pins (A) and a new gasket (B) on the transmission housing (C).





5. Place the flywheel housing (D) on the transmission housing.

6. Install the housing bolts (nineteen), and tighten them to the specified torque in a crisscross pattern in at least two or three steps, then turn the transmission flywheel housing down.

7. Measure the clearance between the set ring (A) and the carrier bearing outer race (B) using a feeler gauge (C).









8. If the clearance is out of standard, remove the set ring, and measure its thickness.

9. Select a new set ring from the following table.

SET RING, 80 mm





10. Install a new set ring, and recheck the clearance and make sure it is within the standard.

11. Install the oil seal to the transmission housing CVT Differential Oil Seal Replacement.