Stabilizer Bushing: Service and Repair

Rear Stabilizer Bushing Replacement

1. Raise and support the vehicle Service and Repair.

2. Remove the dynamic damper from the axle beam Rear Suspension Dynamic Damper Replacement.

3. Remove the stabilizer bushing (A) from the axle beam.





4. Apply silicone spray (P/N 08209-0001) to the new stabilizer bushing. This will ease installation of the bushing into the stabilizer and the axle beam.

5. Make a mark (A) near the hole (B) of the axle beam as shown. Install the stabilizer bushing (C) into the axle beam by aligning the end face of the stabilizer bushing to the plant mark.

NOTE: Make sure the stabilizer bushing is installed into the stabilizer (D).





6. Install the dynamic damper on the axle beam Rear Suspension Dynamic Damper Replacement.