Rear Crankshaft Main Bearing Seal: Service and Repair

Transmission End Crankshaft Oil Seal Installation - In Car

Special Tools Required

- Driver Handle, 15 x 135L 07749-0010000
- Oil Seal Driver Attachment, 96 mm 07ZAD-PNAA100

1. Remove the transmission CVT Transmission Removal.

2. Remove the IMA motor rotor Service and Repair, the IMA motor housing IMA Motor Housing Removal/Installation, and the IMA motor rotor position sensor Service and Repair.

3. Clean and dry the crankshaft oil seal housing.

4. Apply a light coat of new engine oil of the crankshaft oil seal.

5. Use the driver handle, 15 x 135L, and the oil seal driver attachment, 96 mm, to drive a new crankshaft oil seal squarely into the block to the specified installed height.






6. Measure the distance between the cylinder block (A) and the oil seal (B).










7. Install the IMA motor rotor position sensor Service and Repair, the IMA motor housing IMA Motor Housing Removal/Installation, and the IMA motor rotor Service and Repair.

8. Install the transmission CVT Transmission Installation.