Carpet: Service and Repair

Carpet Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to damage, wrinkle or twist the carpet.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Be careful not to damage the dashboard or the interior trim pieces.

1. Do the 12 volt battery terminal disconnection procedure Procedures, then wait at least 3 minutes before beginning work.

2. Remove these items:

- Center console Center Console Removal / Installation
- Front seats, both sides Front Seat Removal / Installation
- Kick panels, both sides Service and Repair
- Front door sill trims, both sides Service and Repair
- B-pillar lower trims, both sides
- Rear door sill trims, both sides
- Rear seat cushion Rear Seat Removal / Installation

3. Pry up the gap detach the clips and the pins (A), then remove the footrest (B).






4. Remove the front area of the carpet (A).

1. Cut the carpet in the area (B) as shown, then remove the carpet.

2. Pull out the seat harnesses (C) through the holes in the carpet.





5. Install the carpet in the reverse order of removal, and note these items:

- Take care not to damage, wrinkle or twist the carpet.
- Make sure the seat harnesses are routed correctly.
- If the clips are damaged or stress-whitened replace them with new ones.
- When installing new carpet, cut the carpet (A) in the area (B) as shown.
- Push the clips into place securely.
- Make sure each connector is plugged in properly.
- Do the 12 volt battery terminal reconnection procedure Procedures.