46-2x

SRS DTC Troubleshooting: 46-2x, 46-3x, 46-Bx

DTC 46-2x, 46-3x, 46-Bx ("x" can be 0 thru 9 or A thru F):

Internal Failure of the Right Side Impact Sensor (second)

NOTE:

- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed Service and Repair.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Clear the DTC memory.

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Read the DTC.

Is DTC 46-2x, 46-3x, or 46-Bx indicated?

YES -

Faulty right side impact sensor (second) or SRS unit; replace the right side impact sensor (second) Side Impact Sensor (Second) Replacement, then clear the DTC, and retest. If the DTC is still present, replace the SRS unit SRS Unit Replacement.�

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.�