Programming and Relearning

Moonroof Control Unit Reset

Resetting the moonroof is required when any of the following have occurred:

- The moonroof was moved manually while the battery was dead or disconnected.

- The moonroof motor was replaced with a new one.

- Any of components related to the moonroof were replaced.
- Wind deflector

- Moonroof glass

- Moonroof glass bracket

- Moonroof cables, etc.

To reset the moonroof control unit, do these steps:

1. Close the driver's door, and keep it closed until the procedure is complete.

2. Turn the ignition switch to LOCK (0).

3. Press and hold the tilt switch, and turn the ignition switch to ON (II).

4. Release the tilt switch, and turn the ignition switch to LOCK (0).

5. Repeat steps 3 and 4 four times.

6. Press and hold the moonroof open switch for at least 3 additional seconds after the moonroof is fully opened.

7. Press and hold the moonroof close switch for at least 3 additional seconds after the moonroof is fully closed (tilted).

8. Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function.