25-22

VSA DTC Troubleshooting: 25-22

DTC 25-22: Yaw Rate Sensor Stuck

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Test-drive the vehicle at 7 mph (10 km/h) or more.
NOTE: Drive the vehicle on the road, not on a lift.

4. Check for DTCs with the HDS.

Is DTC 25-22 indicated?
YES - Go to step 5.

NO - If any other DTCs are indicated, go to the indicated DTCs troubleshooting. If DTCs are not indicated, intermittent failure, the system is OK at this time.


5. Test-drive the vehicle. Check the YAW RATE S in the VSA DATA LIST with the HDS while driving around corners.

Does the indicated value change?
YES - Intermittent failure, the system is OK at this time.

NO - Replace the yaw rate-lateral acceleration sensor. Service and Repair