Console Accessory Power Socket Test/Replacement

Console Accessory Power Socket Test/Replacement

NOTE: If both of the front and rear accessory power sockets do not work, check the No. 35 (7.5 A) fuse in the under-dash fuse/relay box.

1. Remove the center console. Center Console Removal/Installation

2. Disconnect the 2P connector (A) from the console accessory power socket (B).

3. Inspect the connector terminals to be sure they are all making good contact.
- If the terminals are bent, loose, or corroded, repair them as necessary and recheck the system.

- If the terminals look OK, go to step 4.

4. Turn the ignition switch to ACC (I), and measure the voltage between console accessory power socket 2P connector terminal No. 1 and body ground. There should be battery voltage.
- If there is battery voltage, go to step 5.

- If there is no battery voltage, check for:
- Blown No. 28 (15 A) fuse in the under-dash fuse/relay box.

- Faulty console accessory power socket relay.

- Poor ground (G503).

- An open in the wire.

5. Check for continuity between console accessory power socket 2P connector terminal No. 2 and body ground. There should be continuity.
- If there is continuity, replace the console accessory power socket; go to step 6.

- If there is no continuity, check for:
- Poor ground (G601 [G503]).

- An open in the wire.

[ ]: '09 2-door model






6. Remove the socket (A).






7. Remove the housing (A) from the panel.

8. Install the power socket in the reverse order of removal.