Side Impact Sensor (First) Replacement

Side Impact Sensor (First) Replacement

NOTE: Review the seat replacement procedure Front Seat Removal/Installation before doing repairs or service.

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the front seat assembly. Front Seat Removal/Installation

3. Remove the front door sill inner trim:
- 2-door Interior Trim Removal/Installation - Door Sill Area (2-Door)

- 4-door Interior Trim Removal/Installation - Front Door Sill Area (4-Door)

4. Remove the B-pillar lower trim panel. Interior Trim Removal/Installation - B-Pillar Upper/Lower Trim

5. Disconnect the floor wire harness 4P connector (A) from the side impact sensor (first).

6. Using a TORX T30 bit, remove the TORX bolt (B), then remove the side impact sensor (first) (C).






Installation

1. Install the side impact sensor (first) (A) with a new TORX bolt (B), then connect the floor wire harness 4P connector (C) to the side impact sensor (first).

2. Do the battery terminal reconnection procedure. Procedures

3. Reinstall all removed parts.

4. Clear any DTCs. Initial Inspection and Diagnostic Overview

5. Confirm proper operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.