ODS Unit Replacement

ODS Unit Replacement

NOTE: Review the seat replacement procedure Front Seat Removal/Installation before doing repairs or service.

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the passenger's seat assembly Front Seat Removal/Installation and seat-back cover. Front Seat-Back Cover Replacement (2-Door)

3. Disconnect the ODS unit 18P connector (A) and OPDS sensor connectors (B) from the ODS unit (C).

4. Remove the two nuts (D) and the ODS unit.






Installation

1. Place the ODS unit (A) on the seat-back frame. Tighten the two nuts (B), and connect the ODS unit harness 18P connector (C) and OPDS sensor connectors (D) to the ODS unit.

2. Install the seat-back cover in the reverse order of removal.

3. Install the seat assembly. Front Seat Removal/Installation

4. Do the battery terminal reconnection procedure. Procedures

5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.

6. Clear any DTCs. Initial Inspection and Diagnostic Overview

7. Initialize the ODS unit. Programming and Relearning

8. Confirm proper operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.