Subdisplay Visor Removal/Installation

Subdisplay Visor Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*

NOTE:

- Put on gloves to protect your hands.

- Take care not to scratch the dashboard and related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the driver's dashboard lower cover. Drivers Dashboard Lower Cover Removal/Installation

2. Tilt the steering column down, and pull it fully out.

3. Remove the screw.






4. Pull the back of the driver's pocket (A) (4-door) or switch panel (2-door) by hand from the driver's lower cover opening to release the clips (B) and the hook (C) on the outside.

5. Pry up on the inside edge of the subdisplay visor (D) with a trim tool to detach the clip (E), and release the pin (F).






6. Detach the clips along the upper edge of the subdisplay visor (A). Gently pull out the visor to release the hooks (B).






7. Disconnect the illumination control switch connector (A), and the power mirror switch connector (B) (2-door).






8. If necessary, remove the screws, then remove the illumination control switch (A), and the driver's pocket (B) (4-door) or the switch panel (2-door) from the subdisplay visor (C).

9. Install the subdisplay visor in the reverse order of removal, and note these items:
- Make sure all connectors are plugged in properly.

- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips and the hooks into place securely.