Manufacturer Code Charts: 83

TPMS DTC Troubleshooting: 83

DTC 83: No VSP Signal

NOTE: If DTC 85 stored at the same time as DTC 83, troubleshoot DTC 85 first, then recheck for DTC 83.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Test-drive the vehicle at 7 mph (10 km/h) or more.

4. Check the speedometer.

Does the speedometer register speed?
YES - Go to step 5.

NO - Update the ECM/PCM if it does not have the latest software Except Si model, Si model ECM Update, or substitute a known-good ECM/PCM Except Si model Initial Inspection and Diagnostic Overview, Si model, Initial Inspection and Diagnostic Overview then go to step 1 and recheck. If the ECM/PCM was updated and DTCs are not indicated, troubleshooting is complete. If the ECM/PCM was substituted and DTCs are not indicated, replace the original ECM/PCM Except Si model Service and Repair, Si model. Service and Repair


5. Check the VEHICLE SPEED in the TPMS DATA LIST with the HDS.

Is the vehicle speed indicated?
YES - The system is OK at this time.

NO - Substitute a known-good TPMS control unit, Service and Repair and recheck.