FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2008 >> Civic Si L4-2.0L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Actuators and Solenoids - Transmission and Drivetrain >> Actuators and Solenoids - M/T >> Gear Lockout Solenoid >> Service and Repair

Gear Lockout Solenoid: Service and Repair

Reverse Lockout Solenoid Disassembly/Reassembly

1. Make sure you have the anti-theft code for the audio system or the navigation system (if equipped), then write down the audio presets.
2. Disconnect the negative cable from the battery, then disconnect the positive cable.
3. Remove the battery.
4. Remove the air cleaner assembly.
5. Remove the battery base.
6. Disconnect the output shaft (countershaft) speed sensor connector, back-up light switch connector, and reverse lockout solenoid connector.
7. Carefully remove the shift cables, and cable bracket together to avoid bending the shift cables.
8. Remove the three bolts (A) and reverse lockout solenoid (B).





9. Remove the roller (A), the select lock return spring (C), and select lock cam B.





10. Install the components in the reverse order of removal.
11. Clean any the dirt and oil from the sealing surface.
12. Apply liquid gasket, P/N 08718-0001 evenly to the transmission housing mating surface of the reverse lockout solenoid. Install the component within 5 minutes of applying the liquid gasket.

NOTE:
^ If apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
^ If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.

13. Install the reverse lockout solenoid.





14. Install the cable bracket and shift cables.
15. Connect the reverse lockout solenoid connector, back-up light switch connector, and output shaft (countershaft) speed sensor connector.
16. Install the battery base.
17. Install the air cleaner assembly.
18. Install the battery. Clean the battery posts and cable terminals. Connect the positive cable to the battery, then connect the negative cable, and apply multipurpose grease to prevent corrosion.
19. Enter the anti-theft code for the audio system or the navigation system (if equipped), then enter the audio presets. Set the clock (on vehicles without navigation).
20. Do the power window control unit reset procedure.
pro multis Credits:Operation CHARM About Operation CHARM