DTC Fx-xx

DTC Ex-xx, ("x" can be 0 thru 9 or A thru F): Control Operation Recorded

DTC Fx-xx, ("x" can be 0 thru 9 or A thru F): Airbags and/or Tensioner Deployment Recorded

NOTE:
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information.
- DTC E2-11: Front passenger's airbag did not deploy by SRS operation.
- DTC E4-11: Front passenger's side airbag did not deploy by OPDS operation.
- DTC F1-11: Driver's airbag and/or driver's seat belt tensioner and seat belt buckle tensioner deployed.
- DTC F2-11: Front passenger's airbag and/or front passenger's seat belt tensioner and seat belt buckle tensioner deployed.
- DTC F3-11: Driver's side airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.
- DTC F4-11: Front passenger's side airbag, right side curtain airbag, and/or front seat belt tensioner deployed.

1. Erase the DTC memory.
2. Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC Ex-xx or Fx-xx indicated?

YES - Replace the SRS unit.

NO - Check the connectors for looseness, poor pin fit, and poor ground, and repair if needed. If there are no connector problems, the system is OK at this time.

NOTE:
- DTC E2-11 is set if the system triggered airbag deployment but the front passenger's airbag was prevented from deploying because of the seat weight sensor.
- DTC E4-11 is set if the system triggered a passenger's side airbag deployment but the airbag was prevented from deploying by the ODS. Replace the right side impact sensor (first).