Transmission Mount: Service and Repair
Transmission Mount Replacement1. Loosen the upper torque rod mounting bolt (A).
2. Remove the air cleaner housing assembly.
3. Remove the engine control module (ECM) cover, then remove the three bolts securing the ECM.
4. Remove the ECM bracket.
5. Remove the under hood fuse/relay box from the bracket.
6. Support the transmission with a jack and wood block under the transmission.
7. Remove the transmission mount (A).
8. Install the transmission mount with the new mounting bolts (B).
9. Loosely tighten the new bolt and nuts (C).
10. Raise the hoist to full height.
11. Remove the splash shield.
12. Loosen the lower torque rod mounting bolt (A).
13. Loosen the front mount mounting bolt (A).
14. Lower the vehicle on the hoist.
15. Tighten the transmission mounting bolt and nuts.
16. Raise the hoist to full height.
17. Tighten the lower torque rod mounting bolt.
18. Lower the vehicle on the hoist.
19. Tighten the upper torque rod mounting bolt.
20. Install the under-hood fuse/relay box to the bracket.
21. Install the ECM bracket.
22. Install the ECM, then install the ECM cover.
23. Install the air cleaner housing assembly.
24. Raise the hoist to full height, and tighten the front mount mounting bolt.
25. Install the splash shield.