Body/Frame - Universal Subframe Removal Adapter
05-066November 24, 2005
Applies To:
See VEHICLES AFFECTED
Universal Front Subframe Removal Adapter
(Replaces 01-043, Civic Front Sub frame Removal Adapter, dated September 11, 2001)
The universal front subframe removal adapter is a required tool. When properly fitted to a transmission jack and the vehicle's front subframe, the adapter provides a convenient way to remove the subframe. Front subframe removal is required for transmission or engine removal.
NOTE:
The adapter will only support the subframe it will not support the entire powertrain assembly. Refer to the WARNING label on the adapter.
VEHICLES AFFECTED
2003-06 Accord - ALL
2005-06 Accord Hybrid - ALL
2001-06 Civic - ALL
2001-06 Civic GX - ALL
2003-06 Civic Hybrid - ALL
2002-06 Civic Si - ALL
2002-06 CRV - ALL
2003-06 Element - ALL
ORDERING INFORMATION
The universal front subframe removal adapter is TIN VSB02C000016. To order additional adapters, call the Honda Tool and Equipment Program.
USING THE ADAPTER
NOTE:
The adapter is designed to be used with the transmission jack, (new model number NRI-72500D), available through the Honda Tool and Equipment Program. (The old model number LSL-W93714 can still be used.). The adapter also works with many commercially available transmission jacks.
1. Loosen the four bolts that hold the adapter's adjustable arms to its center plate.
2. Line up the slots in the arms with the bolt holes on the corners of the jack base, then attach the adapter to the jack base with the bolts that came with the jack. Tighten all of the bolts securely.
3. Raise the jack to vehicle height.
4. With the rear bar of the adapter spanning the sides of the subframe, route the adapter's strap around the front of the subframe. Pull the strap as tightly as possible, insert the pin through the appropriate loop, then tighten the wing nut.
5. With all of the vehicle parts properly supported or removed (see Engine or Transmission Removal in the appropriate service manual), carefully lower the subframe using the controls on the jack.
Disclaimer