Sunroof / Moonroof Limit Switch: Adjustments

Limit Switch Adjustment

1. Remove the headliner.

Fully closed position adjustment




2. With the moonroof wrench, close the glass (A) fully:
- Make sure both link lifters (B) are parallel, and in the position shown.
- Check the glass fit to the roof panel and the glass height.

3. With an open-end wrench, loosen the limit switch mounting bolts (C).
4. Adjust the limit switch (D):
- Move the switch plate (E) a little at a time, then secure it at the position where you hear a faint click when the switch cam (F) pushes the position switch (open/close).
- Check that the switch plate contacts the switch bracket (G).

Auto-stop position adjustment




5. With the moon roof wrench, operate the glass (A) to the auto-stop position.
6. With an open-end wrench, loosen the auto-stop switch mounting bolts (C).
7. Adjust the auto-stop switch (D):
- Move the switch plate (E) a little at a time, then secure it at the position where you hear a faint click when the switch cam (F) pushes the switch (auto-stop).
- Check that the switch plate contacts the switch bracket (G).

8. Check the operation of the glass by operating the moonroof switch: From the tilt-up position to the fully closed position, from the fully open position to the auto-stop position, from the auto-stop position to the fully closed position.
9. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.