Removal and Installation

NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before
- disconnecting the battery.
- removing the No. 32 (7.5 A) fuse from the under-hood Fuse/Relay box.
- removing the radio.

After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio operation.

1. Disconnect the negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
2. Disconnect the starter cable from the B terminal on the solenoid, then the BLK/WHT wire from the S terminal.

Starter Replacement:

Nippondenso

Starter Replacement:

Mitsuba

3. Remove the two bolts holding the starter, and remove the starter.

Starter Cable Installation:

4. Install in the reverse order of removal.

NOTE: When installing the starter cable, make sure that the crimped side of the ring terminal is facing out.