Combination Switch: Service and Repair

Combination Light Switch Replacement

Combination Light Switch Replacement:

CAUTION:
^ All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
^ Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.
^ For additional precautions, refer to the Air bags and Seat belts.

1. Remove the three screws from the column lower cover.

Combination Light Switch Replacement:

2. Remove the steering column covers.
3. Turn the steering wheel 90° toward the switch.
4. Disconnect the 4P and 7P connectors from the combination light switch.

Combination Light Switch Replacement:

5. Remove the two screws, then pull out the switch.
6. Install in the reverse order of removal.