Set/Resume Switch Test/Replacement

CAUTION:
^ All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
^ Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.
^ For additional precautions, refer to the Air bags and seat belts.

NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before
- disconnecting the battery.
- removing the No. 32 (7.5 A) fuse from the under- hood fuse/relay box.
- removing the radio.
After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio operation.


1. Disconnect the negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.

Set/Resume Switch Test:

2. Remove the dashboard lower cover and knee bolster.
3. Remove the glove box.
4. Disconnect the airbag connectors.

NOTE: The airbag connectors are spring-loaded type.

Set/Resume Switch Test:

5. Disconnect the cable reel sub-harness 3P connector from the main wire harness.

Set/Resume Switch Test:

6. Check for continuity between the terminals of the cable reel sub-harness 3P connector in each switch position according to the table.
^ If there is continuity, and it matches the table, the switch is OK.
^ If there is no continuity in one or both positions, go to step 7.

Set/Resume Switch Test:

7. Remove the two screws, and remove the switch.

Set/Resume Switch Test:

8. Check for continuity between the terminals in switch position according to the table.
^ If there is continuity, and it matches the table, replace the cable reel.
^ If there is no continuity in one or both positions, replace the switch.
9. If all tests prove OK, reinstall the driver's airbag assembly, and reconnect the cable reel sub-harness connector to the main wire harness.
10. Reconnect the driver's and front passenger's airbag connectors.
11. Reconnect the battery positive cable, then the negative cable.
12. After installing, confirm proper system operation:
^ Turn the ignition switch ON (II); the SRS indicator light in the gauge assembly should come on for about six seconds and then go OFF.
^ Make sure the horn works.