Ignition Switch: Testing and Inspection

Ignition Switch Test:

CAUTION:
^ All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
^ Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.
^ For additional precautions, refer to "Air Bags and Seat Belts".

1. Remove the dashboard lower cover and knee bolster.

Ignition Switch Test:

2. Disconnect the 5P connector from the under-dash fuse/relay box, and disconnect the 7P connector from the main wire harness.

Ignition Switch Test:

3. Check for continuity between the terminals in each switch position according to the table.

Ignition Switch Test:

4. If continuity checks do not agree with the table, replace the electrical switch portion of the steering lock assembly.