Engine Control Module: Service and Repair

REM0VAL

1. Turn ignition switch off.
2. Remove the right door sill moulding and the small cover on the right kick panel. Pull the carpet back to expose the PGM-FI ECM.
3. Unbolt the PGM-FI ECM cover.
4. Disconnect the PGM-FI ECM connector and remove the PGM-FI ECM.

INSTALLATION

1. Connect the PGM-FI ECM connector.
2. Position the PGM-FI ECM onto the bolts on the floor.
3. Reinstall the protective cover and secure.
4. Reposition the carpet, kick panel and sill trim.