Repair Procedure

1. Remove the condenser from the vehicle. (Refer to section 22 of the service manual.)

2. Add 20 ml (2/3 oz.) of the proper PAG oil to the new condenser.

1994 Prelude S-Sanden oil
1995 Prelude (ALL)-Hadsys oil

3. Install the new condenser with the new 0-rings that came in the kit.

4. Replace the receiver/dryer.

5. Evacuate the system for 30 minutes.

6. Recharge the system with 650 g (23 oz.) of R-134a refrigerant.

7. Start the engine, run the air conditioner, and test the air temperature at the vents. If the system is blowing warm air, troubleshoot and repair the system before continuing.