Removal and Installation

1. Remove master cylinder as outlined under Master Cylinder, Brakes.
2. Disconnect vacuum hose from booster, then remove vacuum hose bracket.
3. Remove throttle/cruise control cable bracket, then remove throttle cable grommet from engine compartment bulkhead.
4. Remove IAT sensor from intake manifold.
5. Loosen pushrod locknut, then remove the cotter pin and clevis pin.
6. Remove clevis from operating rod of booster.
7. Remove four booster mounting nuts, then pull booster forward and turn right until operating rod is clear of bulkhead, then move operating rod beyond damper by turning booster. Turn booster until operating rod is pointing forward, then remove booster from engine compartment with front cylinder shell of booster pointing up.
8. Reverse procedure to install. Adjust pushrod length before installing booster.