Diagnosis B ("Click" Sound)

1. Test drive the vehicle and verify that a single "click" or "pop" sound is heard when coming to a stop.

2. Disconnect the upper hose from the engine mount solenoid. Plug the hose and the port on the solenoid.

3. Drive the vehicle again and listen for the same sound.

^ If the sound is still there, investigate other causes.

^ If the sound has disappeared, go to Engine Mount Replacement.

Engine Mount Replacement





1. Remove the air intake duct.





2. Disconnect the vacuum hose from the rear engine mount diaphragm. Remove the mounting bolt.

3. Remove two of the three rear engine mount mounting bolts.





4. Remove the bracket between the engine and transmission.

5. Raise the vehicle on a hoist.





6. Remove the center beam (five bolts).





7. Remove the cotter pin and castle nut from the left lower control arm. Use the special tool to separate the lower control arm from the steering knuckle.





8. Disconnect the left drive shaft from the intermediate shaft.





9. Remove the intake manifold bracket.

10. Remove the remaining rear engine mount mounting bolt.

11. Remove the oil filter.

12. EX model only: Remove the oxygen sensor.

13. Remove the rear engine mount by sliding it to the left side of the vehicle.





14. Install the new rear engine mount. Torque the bolts as shown.

15. Reinstall all removed parts.