Procedure 7

Programming the Transmitter

NOTES:
^ Entering the programming mode cancels all learned transmitter codes, so none of the previously programmed transmitters will work. You must reprogram all the transmitters once you're in the programming mode.

^ To keep the system from exiting the programming mode, complete each step within 5 seconds of the previous step, and program the transmitters within 10 seconds of each other.

1. Turn the ignition switch ON (II).

2. Press the "LOCK" or "UNLOCK" button on one of the transmitters. (A non-programmed transmitter can be used for this step.)

3. Turn the ignition switch OFF (0).

4. Repeat steps 1, 2, and 3 two more times with the transmitter used in step 2.

5. Turn the ignition switch ON (II).

6. Press the "LOCK" or "UNLOCK" button on the same transmitter. Check that the power door locks cycle to confirm that you're in the programming mode.

7. Press the "LOCK" or "UNLOCK" button on each transmitter. (You can program up to four transmitters per vehicle) Check that the power door locks cycle after you push each transmitter button, confirming that the system has accepted the transmitter's code.

Ordering the Transmitter

Transmitters can be ordered only by authorized Honda Dealers. Order them from American Honda using normal parts ordering procedures.

Batteries for the Transmitter

The battery number is CR2025. Each transmitter uses one battery.