Impact Sensor: Service and Repair

CAUTION:
^ Do not damage the sensor wiring.
^ Do not install used SRS parts from another car. When repairing an SRS use only new parts.
^ Replace a sensor if it is dented, cracked, or deformed.

1. Disconnect the battery negative cable and then the positive cable.

Short Connector Installation (Driver-Side):

Short Connector Installation (Passenger-Side):

2. Install the short connector(s) on the airbag(s).

Dash Sensor Protector Removal:

3. Remove the footrest and left door sill molding, then pull the carpet back, and remove the dash sensor protector.

Dash Sensor Removal:

4. Remove the two mounting bolts, then remove the dash sensor.

CAUTION:
^ Be sure to install the harness wires so that they are not pinched or interfering with other car parts.
^ Carefully inspect the dash sensors for signs of being dropped or improperly handled, such as dents, cracks or deformation.
^ For the SRS to function properly, the right and left sensors must be installed on the proper sides.

Dash Sensor Installation:

5. Install the dash sensor.
6. Reinstall all other removed parts.
7. Remove and properly store the short connector(s), then reconnect the airbag connector(s) (and reinstall the glove box).
8. Reconnect the battery positive cable, then the negative cable.
9. After installing the dash sensor, confirm proper system operation: Turn the ignition ON (II); the instrument panel SRS indicator light should go ON for about six seconds and then go OFF.