Precautions

NOTICE: The automatic transaxle is an assembly that relies on hydraulic operation. This unit contains numerous seals, O-rings and gaskets that are set to very close tolerances. Any introduction of foreign matter can cause a hydraulic failure. Therefore, all facets of repair operations must be carried out in a clean work environment.

Important
- Keep work areas and tools clean.
- DO NOT use wipe cloths or rags.
- DO NOT use solvents on:
Rubber seals.
Plastic/Teflon thrust washers or spaced.
- Make sure all fluid passages in the case and valve rod are clear and free of any obstruction.

CAUTION: When using compressed air to clear fluid passages and dry parts, always aim air pressure away from face and eyes. Adequate eye protection MUST be worn to avoid injury from dirt and debris that may adhere to parts.

- Blow out all fluid passages with compressed air.
- Clean out small passages with fine wire.
- Handle all parts carefully to prevent damage.
- All parts must be clean and dry before reassembly.

NOTICE: The assembly of some components will require the use of an assembly lube. It is recommended that J 36850 Transjel(tm) transmission assembly lubricant be used during assembly. DO NOT use any other type of grease to retain parts during assembly of this unit. Lubricants other than the recommended assembly lube will change transaxle fluid characteristics and cause undesirable shift conditions and/or fluid pump intake and fluid passage clogging.