Service Procedure

1. Raise vehicle and suitably support.

2. Remove wheel cover (if equipped)

3. Remove tire/wheel.

4. Remove dust cover (not to be reused)

5. Unstack spindle nut.

6. Remove spindle nut (not to be reused) and washer (not to be reused).

7. Remove brake drum (not to be reused)

8. Install NEW brake drum.

9. Install NEW washer and NEW spindle nut and torque to 120 Nm (86.5 lb. ft.) .

10. Stake spindle nut.

11. Install NEW dust cover.

12. Repeat procedure for rear brake drum on other side of vehicle.

13. Lower vehicle.

14. Install Campaign Identification Label.