Identification Lamp Bulb - Installation

BULB

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.





1. Align the base of the bulb (4) with the socket within the identification lamp housing (3).
2. Push the bulb straight into the socket until the base is firmly seated, then rotate the bulb clockwise about 30 degrees to lock it into place.
3. Position the identification lamp lens (2) over the lamp housing.
4. Install and tighten the screw (1) that secures the lens to the lamp housing. Tighten the screw securely.
5. Reconnect the battery negative cable.