Front Lamp Unit Bulb - Installation - Halogen Headlamp

BULB - HALOGEN HEADLAMP

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.





1. Align the halogen high beam (1) or low beam (2) headlamp bulb base with the keyed opening on the back of the front lamp unit reflector.
2. Insert the bulb into the reflector until the base is firmly seated. Be certain that the lugs on the bulb base are engaged in the recesses of the reflector.
3. Pivot the wire bulb retainer over the bulb base, then clip the retainer into place.
4. Reconnect the front lamp unit wire harness connectors to the bulb.





5. Engage the two tabs on the bottom of the front lamp unit rear cover (2) with the two slotted brackets integral to the back of the lamp housing.
6. Swing the rear cover upward into place, then pull upward on the two latches (1) until they snap into place with an audible click.
7. Reconnect the battery negative cable.