Interior Lighting Master Switch - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Align the interior rear lighting master switch (1) with the mounting hole in the face of the instrument cluster bezel (3).
2. Push the switch firmly and evenly into the mounting hole of the bezel until the two latch features (2) on the outside of the switch body snap into place.
3. From the back of the cluster bezel, reconnect the vehicle wire harness connector to the connector receptacle on the back of the switch.
4. Reinstall the cluster bezel onto the instrument panel. .
5. Reconnect the battery negative cable.