Front Crankshaft Oil Seal - Installation

INSTALLATION










NOTE: To prevent potential oil leaks, DO NOT touch the front crankshaft inner seal. Always handle the seal from the outer diameter.

1. Clean timing chain cover (1) seal surface.

NOTE: Keep seal centered in the timing chain cover at all times.

2. Using Seal Installer 8936A, install crankshaft oil seal (2).






CAUTION: Care must be taken when installing the damper. DO NOT damage or gouge the front crankshaft seal

3. Align the alignment key in the crankshaft with the key way in the damper and install the vibration damper.
4. Install the vibration damper bolt (1). Tighten bolt (1) to 210 Nm, plus 180° (154 ft. lbs., plus 90°).





5. Remove Flywheel Locking Tool 9102.
6. Install the starter blank.
7. Install the serpentine belt.Serpentine Accessory Drive Belt - Installation
8. Install the lower radiator hose.
9. Fill the cooling system Service and Repair.
10. Install the air cleaner assembly Air Cleaner Body - Installation
11. Connect negative battery cable.