Installation

INSTALLATION





1. Press center bearing (2) on propeller shaft with protective caps and washer with Installer 9275 (1).

NOTE: If center bearing is equipped with a round flange install new bolt in middle of the flange and tighten to 95 Nm (70 ft. bls.).

2. Install snap-ring.
3. Coat propeller shaft spline with universal grease.
4. Push rubber boot onto propeller shaft.
5. Push together propeller shaft. Pay attention to alignment markings for installation position.
6. Ensure rubber seal is correctly installed and attach new collar clamps.
7. Install propeller shaft.