Automatic Temperature Control (ATC)

AUTOMATIC TEMPERATURE CONTROL (ATC)





1. Position the A/C-heater control (1) to the instrument panel.
2. Connect the wire harness connectors (4) to the back of the A/C-heater control and engage the connector locks (2). Make sure the connector locks are fully engaged.




3. Install the A/C-heater control (2) into the instrument panel (3).
4. Install the four screws (1) that secure the A/C-heater control to the instrument panel. Tighten the screws to 2 Nm (17 in. lbs.).
5. Install the instrument panel center bezel .
6. Reconnect the negative battery cable.
7. If replacing the A/C-heater control, initiate the Actuator Calibration function using a scan tool.