Installation - Front

INSTALLATION





1. Connect the wire harness connector (4) to the blower motor (1).
2. Gently pull the lower right portion of the instrument panel cover (3) slightly rearward to gain clearance and position the blower motor into the HVAC housing (5).
3. Rotate the blower motor clockwise until it is fully seated in the HVAC housing. Make sure the blower motor locking feature is fully engaged to the housing.
4. Install the screw (2) that secures the instrument panel cover to the instrument panel. Tighten the screw securely.
5. Install the right side floor duct.
6. Install the glove box .
7. Reconnect the negative battery cable.